Realtek IPC RTS3917N Demokit

Realtek Camera SoC SoC selection

RTS3917N Demokit

RTS3917N Camera SoC Hardware Platform

The RTS3917N Camera SoC hardware platform, together with peripherals and the related SDK, can realize most of the functions of the RTS3917N SoC, facilitating debugging of various RTS3917N chip functions.

Architecture

The RTS3917N Camera SoC hardware platform structure is shown below:

RTS3917N Block Diagram

Peripherals

RTS3917N Front RTS3917N Back
Interface Description
Power POE 5V Power Input
Speaker Audio Output
SD Card Supports TF Card
Reset Key System Reset
UART Debug Interface UART Debug Interface
Horizontal Motor DC 5V Power, Supports Horizontal Rotation
Vertical Motor DC 5V Power, Supports Vertical Rotation
Ethernet Ethernet Interface
LED Indicators Supports IR_LED and Other LEDs
USB Device USB 5V Power Input
MIC AMIC Audio Input
IR Cut IR Filter Switch Interface

Specifications

Audio/Video
  • AMIC: Supports mono AMIC audio input, uses 2Pin 1.25mm connector with reverse polarity protection, no external power required
  • Speaker out: Provides speaker output (2Pin 1.25mm connector), equipped with Audio Amp
  • IR_CUT: Supports IR-CUT switching interface, uses 2Pin 1.25mm connector, provides IR-CUT motor driver, no external driver required
System
  • Work Mode: 8 working modes: SPI-NOR-Boot-SWD / SPI-NAND-Boot-SWD / ROM Security boot / ROM-DownLoad / SPI-NOR / SPI-NAND / SPI-NOR-ROM-DEBUG / SPI-NAND-ROM-DEBUG
  • Debug Console: Solder serial port wires to connect with a serial debug board for platform debugging
  • SD Socket: Provides MicroSD Interface, supports SD2.0 TF Card, supports hot-plug detection
  • Reset Key: Supports system reset without power-off
Network
  • WiFi: On-board WiFi, supports on-board antenna and external antenna (IPEX), 3.3V power supply
  • Ethernet: Supports Ethernet function, 4Pin 1.25mm connector with reverse polarity protection, compatible with external POE cable
Power
  • Input Power: POE_5V (DC 5V input, 2Pin 1.25mm connector, reverse polarity protection); USB_5V (USB 5V input, 4Pin 1.25mm connector, reverse polarity protection)
  • SoC Power: Core power (0.9V), DDR Power (1.5V), IO Power (3.3V), provided by on-board DC-DC BUCK converter, no external power required
  • Sensor Power: AVDD (2.8V), DOVDD (1.8V), provided by on-board LDO circuit, no external power required
Motor
  • Supports two external stepper motors for horizontal and vertical rotation (with compatible housing)
  • Provides motor driver, no external driver required
  • Connectors use 5Pin 1.25mm connector with reverse polarity protection